Do you provide test results?

Always. OTDR traces and insertion-loss results are documented per fiber and handed over with the as-builts. Without them nobody can prove what the link looked like on day one, which is exactly what you need when it changes.

Can fiber share a trench with the electrical work?

Yes, with proper separation and duct arrangement — and since ZVRGE is doing the electrical duct bank, coordinating both in one trench is usually cheaper and faster than opening the ground twice.

Services / Fiber Optic

The line that carries everything else.

ZVRGE installs, splices and terminates fiber — between buildings, across campuses and inside the facilities that cannot tolerate a bad connection. Every link is tested and the results are handed over with it.

Discuss Your Project Start a Project

What this covers

Single-mode & multimode
Inside plant
Outside plant
Duct & innerduct
Aerial routes
Fusion splicing
Termination & connectorization
Splice enclosures
Patch panels & racks
OTDR & loss testing
As-built documentation

Outside plant

Duct, innerduct and aerial routes between buildings and across sites, pulled at tensions and bend radii the cable is rated for. Fiber does not fail loudly when it is mishandled — it degrades, and the fault shows up as intermittent performance months later.

Route design coordinated with the electrical duct bank where they share a trench
Pull tension and bend radius controlled and recorded
Splice enclosures and slack storage placed for the technician who comes next

Conduit risers on the exterior of a building

Inside plant

Backbone and horizontal runs, pathways, racks, patch panels and terminations inside the building — dressed and labeled so the rack is workable in three years, not just on the day it is handed over.

Splicing and termination

Fusion splicing and field termination with the connector and polish the application calls for. The difference between a link that just passes and one with real margin is entirely in the preparation, and it costs the same to do properly.

Tested, with the results in hand

OTDR traces and insertion-loss testing on every link, documented per fiber. A test result is what turns a fiber install from something that appears to work into something with a known loss budget — and it is what you need the day a link degrades.

Server racks with status lights in a data center

Fiber does not fail loudly. It degrades — which is why every link leaves here tested.

FAQ

Common questions

Yes — duct, innerduct and aerial routes between buildings, and backbone, pathways, racks and terminations inside them. Campus work usually needs both, and splitting them between contractors is where responsibility for a marginal link gets lost.

Talk to us

Have a fiber optic project?

Tell us the scope, the site and the timing. Someone who does this work will come back to you — not a form letter.

Data Centers →Controls & Automation →New Developments →